Indesit DPG-16B1-A-NX-EU User Manual download pdf (Page 28)

Troubleshooting

Whenevertheappliancefailstowork,checkforasolutionfromthefollowinglistbeforecallingforAssistance.

* Only available in selected models.

Problem: Possible causes / Solutions:

The dishwasher does not start or

cannot be controlled.

• Switch off the appliance by pressing the ON/OFF button, switch it back on after approximately

one minute and reset the program.

• The appliance has not been plugged in properly.

• The dishwasher door has not been shut properly.

The door won’t close. • The lock was released. Strongly push the door until a “clacking” noise is heard.

No water drains out from the

dishwasher.

• The dishwasher cycle has not yet nished.

• The water inlet hose is bent (see Installation).

• The drain duct is blocked.

• The lter is clogged up with food residues.

The dishwasher makes excessive

noise.

• The dishes are rattling against each other or against the sprayer arms.

• Excessive foam presence: the detergent has not been measured out correctly or it is not

suitable for use in dishwashers. (see Start-up and use).

The dishes and glasses are covered

in a white lm or limescale deposits.

• The level of the rened salt is low or the dosage setting is not suited to the hardness of the

water (see Rinse aid and salt).

• The lid on the salt dispenser is not closed properly.

• The rinse aid has been used up or the dosage is too low.

The dishes and glasses are streaked

or have a bluish tinge.

• The rinse aid dosage is too high.

The crockery has not been dried

properly.

• A wash cycle without a drying programme has been selected.

• The rinse aid has been used up or the dosage is too low (see Rinse aid and salt).

• The rinse aid dispenser setting is not high enough.

• The crockery is made from non-stick material or plastic.

The dishes are not clean.

• The racks are overloaded (see Loading the racks).

• The crockery has not been arranged well.

• The sprayer arms cannot move freely.

• The wash cycle is too gentle (see Wash cycles).

• Excessive foam presence: the detergent has not been measured out correctly or it is not

suitable for use in dishwashers. (see Start-up and use).

• The lid on the rinse aid compartment has not been shut correctly.

• The lter is dirty or blocked (see Care and maintenance).

• The rened salt level is low (see Rinse aid and salt).

The dishwasher does not take

any water in - Tap shut-off

alarm.

Beeps are heard

* and the Washing

indicator light is ashing quickly.

Beeps are heard* and the Drying and

End indicator lights are ashing quickly.

• There is no water in the mains supply.

• The water inlet hose is bent (see Installation.)

• Turn on the tap and the appliance will start after a few minutes.

• The appliance stopped because no action was taken when the beep

sounded*.

Switch off the machine using the ON/OFF button, turn on the tap and switch

the machine back on after a few seconds by pressing the same button. Re-

program the appliance and restart the wash cycle.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 83 84

Comments to this Manuals

No comments

Indesit DPG-16B1-A-NX-EU User Manual Page 28

Comments to this Manuals

Related products and manuals for Dishwashers Indesit DPG-16B1-A-NX-EU