Indesit IVIA 640 C Instruction for Use download pdf (Page 3)

INSTALLATION

• The cooktop must be set into a worktop between 30 mm and 60 mm deep.

• Install a separator panel under the hob.

• The lower part of the product must not be accessible after installation.

• Do not t the separator panel if an undertop oven is installed.

• The distance between the underside of the appliance and the separator panel

must respect the dimensions given in the gure.

• In order to ensure the correct operation of the product, do not obstruct the

minimum required clearance between the hob and the top of the unit (min. 5 mm).

• If an undertop oven is installed, make sure the oven is equipped with a cooling system.

• For built-in dimensions and installation see the picture in this paragraph.

• A minimum distance must be maintained between the hob and the hood above it. Please refer to the user manual of the hood for more informations.

• Do not install the cooktop near a dishwasher or washing machine, so that the electronic circuits do not come into contact with steam

or moisture, which could damage them.

• In the case of ush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.

• To remove the hob, use a screwdriver (not provided) to prise o the perimeter clips on the underside of the appliance.

PLACING THE HOB

Apply the supplied gasket to the cooktop (unless it has already been tted), after having cleaned its surface. After the electrical connection (see the

chapter “Electrical connection”), position each xing clips on the dedicated slots on the lateral sides of the hob as shown in the picture. Then push

the hob inside the cut out and check that the glass is at and parallel to the worktop. The xing clips are designed for every type of worktop material

(wood, marble, etc.).