Indesit IDL 530 User Manual download pdf (Page 13)

Electrical Connection

If your appliance is supplied with a 13 amp. fused plug it

can be plugged into a 13 amp socket for immediate use.

Before using the appliance please read the instruction

below.

WARNING: THIS APPLIANCE MUST BE EARTHED.

THE FOLLOWING OPERATIONS SHOULD BE CARRIED

OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved

fuse to BS 1362 should always be used, and the fuse

cover re-fitted. If the fuse cover is lost, the plug must not

be used until a replacement is obtained.

Replacemente fuse covers:

If a replacement fuse cover is fitted, it must be of the

correct colours as indicated by the coloured marking or

the colour that is embossed in words on the base of the

plug. Replacements can be obtained directly from your

nearest Service Depot.

Removing the plug:

Ifyour appliance has a non-rewireable moulded plug and

you should wish to remove it to re-route the mains cable

through partitions, units etc., please esure that either:

- the plug is replaced by a fused 13 amp re-wireable plug

bearing the BSI mark of approval

- or:

- the mains cable is wired directly into a 13 amp cable

outlet, controlled by a switch, (in compliance with BS

5733) which is accessible without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make

the pins unusable so that it cannot be accidentally inserted

into a socket.

Instruction for connecting cable to an altenative plug:

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow - Earth

Blue - Neutral

Brown - Live

CAUTION:

Once the appliance has been installed, the electrical plug

and socket should remain accessible.

- If the power supply cable is damaged, it must be replaced

by the manufacturer or its Technical Assistance Service

in order to prevent all potential hazards. (See Assistance)

- The cable should not be bent or compressed.

- The Company shall not be held responsible for any

incidents that occur if these regulations are not observed.

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminal in your plug, proceed as follows:

connect Green & Yellow wire to terminal market E or

coloured Green or Green & Yellow or:

Connect Brown wire to terminal marked L or coloured

Red.

Connect Blue wire to terminal marked N or coloured

Black.

If a 13 amp plug (BS 1363) is used it must be fitted

with a 13 amp fuse. A15 amp plug must be protected

by a 15 amp fuse, either in the plug or adaptor or at

the distribution board.

If you are in any doubt about the electrical supply to

your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance

with the following code:

BLUE NEUTRAL (N)

BROWN LIVE (L)

GREEN AND YELLOW EARTH (E) or

Disposing of the appliance:

When disposing of the appliance please remove the

plug by cutting the mains cable as close as possible to

the plug body and dispose of it as described above.

The Company shall not be held responsible for any

incidents that occur if these regulations are not

observed.

Electrical Connection

1 ... 12 13 14 15 16

Comments to this Manuals

No comments

Indesit IDL 530 User Manual Page 13

Comments to this Manuals

Related products and manuals for Dishwashers Indesit IDL 530