Indesit TV 631 (BK) GH Instruction for Use download pdf (Page 21)

Replacing the Mini DUAL burner nozzles*

1. Remove the hob grids and slide the burners off their seats. The burner

consists of two separate parts.

2. Loosen the 3 screws and remove the burner.

3. Loosen the 2 screws (see gure).

4. Unscrew nozzle “A” using a 7 mm socket

spanner. Use a spanner with a 7 mm opening

to unscrew nozzle “B” (see gure). Replace

the nozzles with models which are suitable for

use with the new type of gas (see table 1).

5. Replace all the components by following the above instructions in reverse.

• Adjusting the burners’ primary air

Does not require adjusting.

• Setting the burners to minimum

1. Turn the tap to the low ame position;

2. Remove the knob and adjust the adjustment screw, which is positioned

in or next to the tap pin, until the ame is small but steady.

3. Having adjusted the ame to the required low setting, while the burner is

alight, quickly change the position of the knob from minimum to maximum

and vice versa several times, checking that the ame does not go out.

4. Some appliances have a safety device (thermocouple) tted. If the device

fails to work when the burners are set to the low ame setting, increase

this low ame setting using the adjusting screw.

5. Once the adjustment has been made, replace the seals on the by-passes

using sealing wax or a similar substance.

! If the appliance is connected to liquid gas, the regulation screw must be

fastened as tightly as possible.

! Once this procedure is nished, replace the old rating sticker with one

indicating the new type of gas used. Stickers are available from any of our

Service Centres.

! Should the gas pressure used be different (or vary slightly) from the

recommended pressure, a suitable pressure regulator must be tted to the

inlet pipe (in order to comply with current national regulations).

Electrical

connections

DATA PLATE

EU Regulation no. 66/2014 implementing

Directive 2009/125/EC.

standard EN 60350-2

standard EN 30-2-1

ECODESIGN

see data plate

This appliance conforms to the following

European Economic Community directives:

- 2006/95/EC dated 12/12/06 (Low Voltage)

and subsequent amendments

- 2004/108/EC dated 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments

- 93/68/EEC dated 22/07/93 and subsequent

amendments.

- 2009/142/EC dated 30/11/06 (Gas) and

subsequent amendments

- 2012/19/EU and subsequent amendments.

* Only available on certain models.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 63 64

Comments to this Manuals

No comments

Indesit TV 631 (BK) GH Instruction for Use Page 21

Comments to this Manuals

Related products and manuals for Hobs Indesit TV 631 (BK) GH