Indesit AQXXMD 129 (EX) Instruction for Use download pdf (Page 14)

Troubleshooting

Possible causes / Solutions:

 The plug has not been inserted into the electrical socket, or it has not

been inserted far enough to make contact.

 There is no power in the house.

 The porthole door has not been shut properly.

 The START/PAUSE button has not been pressed.

 The water tap has not been turned on.

 The water inlet hose is not connected to the tap.

 The hose is kinked.

 The water tap has not been turned on.

 There is no water in the house.

 The water pressure is insufficient.

 The START/PAUSE button has not been pressed.

 The end of the outlet hose has not been fitted at a height between 65

and 100 cm from the floor (see Installation).

 The free end of the hose is underwater (see Installation).

 If If the dwelling is on one of the upper floors of a building, there may be

problems relating to water drainage, causing the washer-dryer to load

and drain water continuously. Special anti-draining valves are available in

shops and help to avoid this inconvenience.

 The water drainage systemis not fitted with a breather pipe.

 The programme does not include a draining phase: some programmes

require manual draining (see Programmes and options).

 The Easy Iron option is enabled: to complete the programme, press

the START/PAUSE button (see Programmes and options).

 The outlet hose is bent (see Installation).

 The drainage duct is clogged.

 The drum was not unlocked properly when the appliance was installed (see Installation).

 The washer-dryer is not level (see Installation).

 The washer-dryer is trapped between cabinets and a wall (see Installation).

 The load is not balanced properly (see Description of the machine).

 The water inlet hose is not screwed on to the tap correctly (see Installation).

 The detergent dispenser drawer is blocked (for instructions on how to

clean it, see Care and maintenance).

 The outlet hose has not been secured properly (see Installation).

 Switch off the machine and unplug the appliance; wait for approximately

1 minute then switch it on again.

If the problem persists, contact Assistance.

 The detergent is not designed for machine washing (the packaging should state that

the product is for washing by machine, for washing by hand or machine or similar).

 Too much detergent was used.

 Follow the manual unlocking procedure (see Precautions and tips).

 The appliance is not plugged into the socket, or not enough to make contact.

 There has been a power failure.

 The appliance door is not shut properly.

 A delayed start has been set.

 The DRYING cycle is on the OFF setting.

From time to time your machine may not operate as it should. Before calling for Assistance (see Assistance),

make sure that the problem cannot be resolved easily using the following list.

Malfunction:

The washer-dryer

will not switch on.

The wash cycle

does not begin.

The washer-dryer fails to fill

with water.

The machine continuously fills

and drains water.

The washer-dryer does not

drain or spin.

The washer-dryer vibrates

too much during the spin cycle.

The washer-dryer leaks.

The icons corresponding to the Phase

in progress flash rapidly at the same

time as the ON/OFF indicator light.

There is too much foam.

The washer-dryer door remains locked.

The washer-dryer does not dry.

1 ... 13 14 15 ... 64

Comments to this Manuals

No comments

Indesit AQXXMD 129 (EX) Instruction for Use Page 14

Comments to this Manuals

Related products and manuals for Washing machines Indesit AQXXMD 129 (EX)