EN
29
* Only available in selected models.
Starting the dishwasher
1.PresstheON/OFFbutton:
2. Open the door and pour in a suitable amount of detergent.
3.Loadtheracks
(seeLoadingtheracks)
and shut the door.
4.Select the wash cycle by turningthe WASH CYCLE
SELECT knob clockwise: align the notch in the knob with
thenumber/symbolrepresentingthedesiredwashcycle.The
START/PAUSEindicatorlightwillgoon.
5.Select the wash options*
(seeSpecial wash cycles and
options.)
6.StartthecyclebypressingtheStart/Pausebutton:abeepwill
sound* and the indicator light corresponding to the wash
phase will go on to signal that the cycle has begun.
7. At the end a few beeps * will signal the end of the wash cycle
and the ENDindicatorlightwillgoon.Switchofftheappliance
bypressingtheON/OFFbutton.
8.Wait a few minutes before removing the crockery to avoid
getting burnt. Unload the racks, beginning with the lower level.
The machine will switch off automatically during
certain periods of inactivity in order to minimise
electricity consumption.
Changing a wash cycle in progress
If a mistake was made in the wash cycle selection process, it
is possible to change the cycle provided that it has only just
begun: once the wash cycle has started, in order to change
the wash cycle switch off the machine by pressing and holding
theON/OFF/Resetbutton.Switchitbackonusingthesame
button and select the desired wash cycle and options.
Adding extra crockery
PresstheStart/Pausebutton-thecorrespondingindicator
light will flash. Open the door, taking care to avoid the
escaping steam, and place the crockery inside the appliance.
Pressthe Start/Pausebutton (fixed light): the cyclestarts
again.
IftheStart/Pausebuttonispressedsoastopausethe
machine,boththewashcycleandtheDelayedStartfunction
(ifselected)areinterrupted.
At this stage the wash cycle cannot be changed.
Accidental interruptions
If the door is opened during the wash cycle or there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the
electricity supply restored.
Detergent and
dishwasher use
Measuring out the detergent
Good washing results also depend on the correct amount of
detergent being used. Exceeding the stated amount does not
result in a more effective wash and increases environmental
pollution.
The amount can be adjusted to the soil level.
In the case of normally soiled items, use approximately either
35g (powder detergent) or 35ml (liquid detergent). If tablets
are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed
with water before being placed in the dishwasher, reduce the
amount of detergent used accordingly.
For good washing results also follow the instructions shown
on the detergent box.
For further questions please ask the detergent producers.
To open the detergent dispenser use the opening device “A”.
Introduce the detergent into the dry dispenser “B” only.
Place the amount of detergent for pre-washing directly inside
the tub.
1. When measuring out the detergent refer to the Table of wash
cycles to add the proper quantity. Compartment B comprises a
levelshowingthemaximumquantityofliquidorpowderdetergent
that can be added to each cycle.
2.Removedetergentresiduesfromtheedgesofthedispenser
and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until
the closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the wash cycle.
Ifall-in-onedetergentsareused,werecommendusingtheTABS
option, because it adjusts the cycle so that the best washing and
drying results are always achieved.
Only use detergent which has been specifically designed
for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam residues
remaining in the machine after the cycle has ended.
To achieve the best washing and drying results, the combined
use of detergent, rinse aid liquid and refined salt is required.
We recommend using detergents that do not contain
phosphates or chlorine, as these products are harmful
to the environment.
Comments to this Manuals