Indesit IDL 530 User Manual download pdf (Page 12)

Installation

Positioning the Appliance

Position the appliance in the desired location. The back

should rest against the wall behind it, and the sides, along

the adjacent cabinets or wall. The dishwasher is equipped

with water supply and drain hoses that can be positioned

to the right or the left to facilitate proper installation.

Levelling the Appliance

Once the appliance is positioned, adjust the feet (screwing

them in or out) to adjust the height of the dishwasher,

making it level. In any case, the appliance should not be

inclined more than 2°.

If the appliance is level, it will help ensure proper perfor-

mance.

This dishwasher model can be built under a single worktop

(please read the relevant instruction sheet).

Anti-flooding protection

Your dishwasher is provided with a special system which

blocks the water supply in the event of leaks inside the

appliance.

Cold water connection.

This electric household appliance should be connected

to the water mains using the cold water supply hose

provided with the appliance only. Do not use a different

hose. In the event of replacements, use original spare

parts only.

Connect the cold water supply hose to a 3/4 gas threaded

connection, taking care to screw it tightly onto the tap.

If the water hoses are new or have been out of use for an

extended period of time, let the water run to make sure it

is clear and free of impurities before making the

connection. If this precaution is not taken, the water inlet

could get blocked, causing damage to your dishwasher.

Hot Water Connection

The water supply to the appliance can also be connected

to the house's hot water line (centralised system, heating

system), as long as it does not exceed a temperature of

60° C.

In this case, the wash cycle time will be shortened by

about 15 minutes and the wash efficiency slightly reduced.

The connection must be made to the hot water line

following the same procedures as those for the connection

to the cold water line.

Drain Hose Connection

Fit the drain pipe into a drain line with a minimum diameter

of 4 cm or place it over the

sink. Avoid restricting or

bending it. Use the special

plastic elbow provided (see fi-

gure) to position it in the best

possible way. The part of the

pipe marked with the letter A

should be between 40 and 100

cm above the ground.

The pipe should not be

immersed in water.

WARNING: HAZARDOUS VOLTAGE!

Electrical Connection

After making sure that the voltage and frequency values

for the current in the home correspond to those on the

rating plate (located on the stainless steel inner door of

the appliance) and that the electrical system is sized for

the maximum voltage on the rating plate, insert the plug

into an electrical socket which is earthed properly (the

earthing of the appliance is a safety requirement mandated

by law). If the electrical socket to which the appliance

must be connected is not appropriate for the plug, replace

the plug, rather than using adpators or the like as they

could cause overheating and burns.

 Once the appliance has been installed, the power

supply cable and the electrical socket should be easily

accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must be

replaced by the manufacturer or its Technical

Assistance Service in order to prevent all potential

hazards. (See Assistance)

The Company shall not be held responsible for any

incidents that occur if these regulations are not

observed.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Indesit IDL 530 User Manual Page 12

Comments to this Manuals

Related products and manuals for Dishwashers Indesit IDL 530