Indesit PKQ755DGH(K) AUS.1 Instruction for Use download pdf (Page 5)

Installation

! Before operating your new appliance please read this instruction booklet

carefully. It contains important information for safe use, installation and care

of the appliance.

! Please keep these operating instructions for future reference. Pass them on

to possible new owners of the appliance.

! This appliance must be installed by an authorised person in accordance with

this instruction manual, AS/NZS 5601.1 – Gas installations (installation and

pipe sizing), local gas tting regulations, local electrical regulations, Building

Code of Australia and any other government authority.

Positioning

! Keep packaging material out of the reach of children. It can become a choking

or suffocation hazard (see Precautions and tips).

! The appliance must be installed by a qualied professional according to the

instructions provided. Incorrect installation may cause harm to people and

animals or may damage property.

! This unit may be installed and used only in permanently ventilated rooms.

The following requirements must be observed:

• The room must be equipped with an air extraction system that expels

any combustion fumes. This may consist of a hood or an electric fan that

automatically starts each time the appliance is switched on.

In a chimney stack or branched flue.

(exclusively for cooking appliances)

Directly to

the Outside

• The room must also allow proper air circulation, as air is needed for

combustion to occur normally. The ow of air must not be less than 2 m

per kW of installed power.

The air circulation system may take air directly

from the outside by means of a pipe with an

inner cross section of at least 100 cm

; the

opening must not be vulnerable to any type

of blockages.

The system can also provide the air needed for

combustion indirectly, i.e. from adjacent rooms

tted with air circulation tubes as described

above. However, these rooms must not be

communal rooms, bedrooms or rooms that

may present a re hazard.

• Intensive and prolonged use of the appliance may necessitate

supplemental ventilation, e.g. opening a window or increasing the power

of the air intake system (if present).

Examples of

ventilation holes

for comburant air.

Enlarging the ventilation slot

between window and floor.

Adjacent

Room

Room to be

Vented

Fitting the appliance

Gas inlet is located at the rear left hand side 25 mm in from the rear edge.

Overhead clearances-(Measurement A).

Range hoods and exhaust fans shall be

installed

in accordance with the manufacturer’s relevant

instructions. However, in no case shall the

clearance between the highest part of the

hob of the gas cooking appliance and a range

hood be less than 600 mm or, for an overhead

exhaust fan, 750 mm.

Side clearances—(Measurements B, & C) Where B, measured from the

periphery of the nearest burner to any vertical combustible surface, or vertical

combustible surface covered with toughened glass or sheet metal, is less

than 200 mm, the surface shall be protected to a height C of not less than

150 mm above the hob for the full dimension (width or depth) of the cooking

surface area. Where the gas cooking appliance is tted with a “splashback”,

protection of the rear wall is not required.

• The installation cavity should have the dimensions indicated in the gure.

Fastening hooks are provided, allowing you to fasten the hob to tops that

are between 20 and 40 mm thick. To ensure the hob is securely fastened

to the top, we recommend you use all the hooks provided.

555 mm

55 mm

475 mm

Before the installation remove the grids and burners from the hob and turn it

upside down, making sure you don’t damage the thermocouples and spark

plugs.

Apply the seals that come with the

appliance along the outer edges of

the hob to prevent any passage of air,

humidity and water (see Figure).

For proper application make sure the

surfaces to be sealed are clean, dry and

free of any grease/oil.

This appliance must be installed with the following clearances:

55 mm clearance from bench top (sides)

5 mm clearance from bench top (front & rear)

Side clearance 55 mm Front and rear clearance 5 mm

Front

Hooking position for top H=40mm Back

! Use the hooks contained in the “accessory pack”.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Indesit PKQ755DGH(K) AUS.1 Instruction for Use Page 5

Comments to this Manuals

Related products and manuals for Hobs Indesit PKQ755DGH(K) AUS.1