Indesit FIMS 51 K.A IX Instruction for Use download pdf (Page 14)

DATA PLATE

Dimensions

width cm 43.5

height cm 32

depth cm 40

Volume

lt. 56

Electrical

connections

voltage: 220-240V ~ 50/60 Hz

(see data plate)

maximum power absorbed 2250W

ENERGY LABEL

Directive 2002/40/EC on the label

of electric ovens.

Standard EN 50304

Models with cooling ventilation:

Energy consumption for Natural

convection heating mode:

Convection

Declared energy consumption for

Forced convection Class heating

mode: Multi-cooking

Models without cooling

ventilation:

Energy consumption for Forced

convection heating mode:

Multi-cooking

Declared energy consumption for

Natural convection Class heating

mode: Convection

This appliance conforms to the

following European Economic

Community directives:

2006/95/EEC of 12/12/06 (Low

Voltage) and subsequent

amendments;

-2004/108/EEC of 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments;

93/68/EEC of 22/07/93 and

subsequent amendments.

2002/96/EC and subsequent

amendments.

Electrical connections

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating

current at the voltage and frequency indicated on

the data plate located on the appliance (

see below

Fitting the power supply cable

1. Open the terminal

board by inserting a

screwdriver into the

side tabs of the cover.

Use the screwdriver as

a lever by pushing it

down to open the cover

(

see diagram

2. Install the power

supply cable by

loosening the cable

clamp screw and the

three wire contact

screws L-N-

Connect the wires to the

corresponding terminals:

the Blue wire to the

terminal marked (N), the

Brown wire to the

terminal marked (L) and

the Yellow/Green wire to

the terminal marked

(

see diagram

3. Secure the cable by

fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the

load indicated on the data plate (

see side

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum

contact opening of 3 mm installed between the

appliance and the mains, suitable for the load indicated

and complying with current electrical regulations (the

earthing wire must not be interrupted by the circuit-

breaker). The supply cable must not come into contact

with surfaces with temperatures higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure that:

• The appliance is earthed and the plug is

compliant with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated on the data

plate (

see below

• The voltage must be in the range between the

values indicated on the data plate (

see below

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it.

Do not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only (

see Assistance

! The manufacturer declines any liability should

these safety measures not be observed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 71 72

Comments to this Manuals

No comments

Indesit FIMS 51 K.A IX Instruction for Use Page 14

Comments to this Manuals

Related products and manuals for Microwaves Indesit FIMS 51 K.A IX