Indesit ON 837 I RFH Instruction for Use download pdf (Page 12)

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack. For more thorough cleaning purposes, the oven

door may be removed:

1. Open the oven door fully (see diagram);

2. Lift up and turn the small levers located on the two hinges (see diagram);

Grip the door on the two external sides

and close it approximately half way.Pull

the door towards you lifting it out of its seat

(see diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-

holder.

2. Remove the light bulb and replace it with a

similar one: Wattage 25 W, cap E 14.

3. Replace the glass cover (see diagram).

! Do not use the oven lamp as/for ambient lighting.

Sliding Rack Kit assembly

To assemble the sliding racks:

1. Loosen the two screws A (see

diagram). If the oven is tted with self-

cleaning panels, these will have to be

temporarily disassembled.

2. Replace the screws A with the screws

and spacers (B + C) supplied with the kit.

3.Tighten the new screws B and the

corresponding spacers C, tting the self-

cleaning panels on again.

4. Secure the two joints D of the guide

rail in the holes provided on the oven

walls (see diagram). The holes for the

left guide rail are situated at the top,

while the holes for the right one are at

the bottom.

5. Finally, t the guide rail on the spacer

! Do not place the sliding racks in position 5.

Side and rear catalytic liners

These are panels coated with a special enamel, which is able to absorb the

fat released by food as it cooks.

This enamel is quite strong, so that the various accessories (racks, dripping

pans, etc.) can slide along them without damaging them. White marks may

appear on the surfaces; these are not a cause for concern.

Nevertheless, the following should be avoided:

- scraping the enamel with sharp objects (a knife, for example);

- using detergents or abrasive materials.

C B

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Indesit ON 837 I RFH Instruction for Use Page 12

Comments to this Manuals

Related products and manuals for Microwaves Indesit ON 837 I RFH