Indesit K1G20S(B)/I Instruction for Use download pdf (Page 17)

c) Minimum regulation of the hob burners:

•

turn the tap to minimum;

• remove the knob and adjust the regulation screw, which

is positioned in or next to the tap pin, until the flame is

small but steady.

N.B.: in the case of liquid gas, the regulation screw

must be screwed in to the bottom.

• check that the flame does not turn off when you turn

the tap quickly from high to low.

d) Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

Adapting the gas oven to different types of gas

a) Replacing the oven burner nozzle:

• remove the warming drawer;

• remove the sliding protection “A” (see Fig.C);

• remove the screw and then the oven burner “V”(see

Fig. D). Remove the oven door to facilitate this

operation.

• unscrew the oven burner nozzle using the special

socket spanner for the nozzles (see Fig. E), or better

still a 7 mm socket spanner, and replace it with a nozzle

suited to the new type of gas (see table 1).

Fig. C Fig. D

Fig.E

b) Minimum regulation of the oven burner without

thermostat:

• light the burner as described in the paragraph “the oven

knob” of the instruction booklet;

• take the knob to minimum, indicated by +.

• remove the knob and turn the regulation screw which is

positioned in or next to the tap pin until the flame is

small but steady.

N.B.: in the case of liquid gas, the regulation screw

must be screwed in to the bottom;

• check that the burner does not turn off when you turn

the knob from high to low or when you open and close

the oven door quickly.

Important

On completion of the operation, replace the old rating

sticker with one indicating the new type of gas used. This

sticker is available from our Service Centres.

Note

Should the pressure of the gas used be different (or vary)

from the recommended pressure, it is necessary to fit a

suitable pressure regulator onto the inlet pipe in compliance

with current National Regulations relative to “regulators for

channelled gas”.

WARNING

To remove the sliding protection “A”, unscrew screw “S”.

When you have finished, replace the protection and lock it

in place with screw “S”.

Before using the oven, make sure the sliding protection

“A” is fastened in the correct position.

1 ... 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Indesit K1G20S(B)/I Instruction for Use Page 17

Comments to this Manuals

Related products and manuals for Hobs Indesit K1G20S(B)/I