Indesit FK 99EJ 0 X/HA Instruction for Use download pdf (Page 30)

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out

any work on it.

Cleaning the appliance

• Slight differences in colour on the front of the oven are due to the different

materials used, i.e. glass, plastic or metal.

• Any shady areas resembling grooves on the oven door glass are caused

by reections from the oven light.

• The enamel is branded at very high temperatures. This process may cause

colour variations. This is normal and will not affect appliance operation in

any way. The thin edges of the sheet metal cannot be entirely enamelled

and may therefore appear to be unnished. This will not affect the rust

protection.

• The stainless steel or enamel-coated external parts and the rubber seals

may be cleaned using a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the removal of stubborn

stains. After cleaning, rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned after each use, while it is

still lukewarm. Use hot water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding racks - can be washed

like everyday crockery, and are even dishwasher safe.

• We recommend that detergents are not sprayed directly onto the control

panel, but that a sponge is used instead.

! Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

! The door of LED INSIDE models cannot be removed.

Clean the glass part of the oven door using a sponge and a non-abrasive

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack.

For more thorough cleaning purposes, the oven door may be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small levers F located on the two

hinges (see diagram).

3. Grip the door on the two outer sides and

close it approximately half way. Pull the

door towards you, lifting it out of its slot (see

diagram). To replace the door, reverse this

sequence.

To remove oven door with soft closing hinges*:

1. Open the door completely.

2. Lift the pull-out hooks located on the two

hinges. If you cannot lift them manually, use

a tool as a lever.

3. Completely rotate downwards the pull-out

hooks.

4. Holding the door by its two outer sides,

slowly close it but not completely. Pull the

door to remove it from its seat (see gure).

To re-assemble the door follow the procedure

in reverse order.

5. Rotate the pull-out hooks upwards until they

touch the front of the oven.

6. Push the pull-out hooks downwards,

making sure they are steady and do not

rotate forward.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

* Only available in certain models.

1 ... 29 30 31 ... 64

Comments to this Manuals

No comments

Indesit FK 99EJ 0 X/HA Instruction for Use Page 30

Comments to this Manuals

Related products and manuals for Ovens Indesit FK 99EJ 0 X/HA