Indesit FZ 87.1 IX NE Instruction for Use download pdf (Page 3)

DATA PLATE

Dimensions

width 43.5 cm

height 32 cm

depth 41,5 cm

Volume

lt. 58

Electrical

connections

voltage: 230-240V ~ 50Hz

maximum power absorbed

2800-3000W

ENERGY LABEL

Directive 2002/40/EC on the label

of electric ovens.

Standard EN 50304

Energy consumption for Natural

convection – heating mode:

Convection mode.

Declared energy consumption for

Forced convection Class – heating

mode: Baking.

This appliance conforms to the

following European Economic

Community directives:

73/23/EEC of 19/02/73 (Low

Voltage) and subsequent

amendments;

- 89/336/EEC of 03/05/89

(Electromagnetic Compatibility) and

subsequent amendments;

- 93/68/EEC of 22/07/93 and

subsequent amendments.

Electrical connections

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating current

at the voltage and frequency indicated on the data

plate located on the appliance (see below).

Fitting the power supply cable

1. Open the terminal

board by inserting a

screwdriver into the side

tabs of the cover. Use

the screwdriver as a

lever by pushing it down

to open the cover (see

diagram).

2. Install the power

supply cable by

loosening the cable

clamp screw and the

three wire contact

screws L-N-

. Connect

the wires to the

corresponding

terminals: the Blue wire

to the terminal marked

(N), the Brown wire to

the terminal marked (L) and the Yellow Green wire to

the terminal marked

(see diagram).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate (see side).

The appliance must be directly connected to the

mains using an omnipolar circuit-breaker with a

minimum contact opening of 3 mm installed between

the appliance and the mains, suitable for the load

indicated and complying with current electrical

regulations (the earthing wire must not be interrupted

by the circuit-breaker). The supply cable must not

come into contact with surfaces with temperatures

higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure that:

 The appliance is earthed and the plug is compliant

with the law.

 The socket can withstand the maximum power of

the appliance, which is indicated on the data plate

(see below).

 The voltage must be in the range between the

values indicated on the data plate (see below).

 The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it. Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

! The manufacturer declines any liability should

these safety measures not be observed.

1 2 3 4 ... 52

Comments to this Manuals

No comments

Indesit FZ 87.1 IX NE Instruction for Use Page 3

Comments to this Manuals

Related products and manuals for Ovens Indesit FZ 87.1 IX NE