Indesit KN6E61A(W)/FR Instruction for Use download pdf (Page 20)

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

! Do not use abrasive or corrosive detergents such

as stain removers, anti-rust products, powder

detergents or sponges with abrasive surfaces: these

may scratch the surface beyond repair.

! Never use steam cleaners or pressure cleaners on

the appliance.

• It is usually sufficient simply to wash the hob

using a damp sponge and dry it with absorbent

kitchen roll.

• The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse well and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• For hobs with electronic ignition, the terminal part

of the electronic lighting devices should be

cleaned frequently and the gas outlet holes

should be checked for blockages.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• Clean the glass oven door using non-abrasive

products and sponges and dry it with a soft cloth.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

• Stainless steel can be marked by hard water that

has been left on the surface for a long time, or by

aggressive detergents containing phosphorus.

After cleaning, rinse well and dry thoroughly. Any

remaining drops of water should also be dried.

! Do not close the cover when the burners are alight

or when they are still hot.

Inspecting the oven seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

Authorised After-sales Service Centre. We

recommend that the oven is not used until the seals

have been replaced.

Replacing the oven light bulb

1. After disconnecting the oven

from the electricity mains,

remove the glass lid covering

the lamp socket (

see figure

2. Remove the light bulb and

replace it with a similar one:

voltage 230 V, wattage 25 W,

cap E 14.

3. Replace the lid and reconnect the oven to the

electricity supply.

Assistance

Please have the following information handy:

• The appliance model (Mod.).

• The serial number (S/N).

This information can be found on the data plate

located on the appliance and/or on the packaging.

11/2010 - 195086749.00

XEROX FABRIANO

1 ... 19 20

Comments to this Manuals

No comments

Indesit KN6E61A(W)/FR Instruction for Use Page 20

Comments to this Manuals

Related products and manuals for Ovens Indesit KN6E61A(W)/FR