Indesit IWDE 7145 B (EU) Instruction for Use Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
GB
3
Technical data
Model
IWDE 7145
Dimen-
sions
width 59.5 cm
height 85 cm
depth 53,5 cm
Capacity
from 1 to 7 kg for the wash
programme;
from 1 to 5 kg for the drying
programme
Electrical
connec-
tions
please refer to the technical
data plate fixed to the machine
Water
connec-
tions
maximum pressure 1 MPa
(10 bar)
minimum pressure 0.05 MPa
(0.5 bar)
drum capacity 52 litres
Spin
speed
up to 1400 rotations per minute
Energy
rated
program-
mes ac-
cording
to regula-
tion
EN 50229
Wash: programme 2; tempera-
ture 60°C; using a load of 7 kg.
Drying: first drying cycle
performed with a 2 kg load,
selecting drying level “A1
(IRON DRY); second drying
cycle performed with a 5 kg
load, selecting drying level
A4” (EXTRA DRY).
This appliance conforms to the
following EC Directives:
- 2004/108/CE (Electroma-
gnetic Compatibility) and sub-
sequent modifications
- 2012/19/EU - WEEE
- 2006/95/EC (Low Voltage)
65 - 100 cm
Connecting the drain hose
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
the socket is earthed and complies with all
applicable laws;
the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been installed,
the electricity socket must be within easy reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.
The first wash cycle
Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, using the wash cycle 2.
Page view 2
1 2 3 4 ... 60

Comments to this Manuals

No comments