Indesit IDL 55 T4C Instruction for Use download pdf (Page 17)

Starting the dishwasher

1. Turn the water tap on.

2. Press the ON/OFF button: the indicator light will

illuminate.

3. Open the door and pour in a suitable amount of

detergent (

see below

4. Load the racks (

see Loading the racks

) and shut

the door.

5. Select the desired wash cycle depending on the

dishes and how dirty they are (

see table of wash

cycles

), by turning the knob clockwise.

6. Select the wash options (see below).

7. Start the cycle by pressing the START/RESET

button: the machine will emit a confirmation beep.

The WASH CYCLE PHASE indicator lights display

the status of the cycle:

Pre-wash, Wash, Rinse, or Drying.

8. At the end of the cycle three short beeps will

sound and the DRYING indicator light will flash.

9. Switch off the appliance by pressing the ON/OFF

button, shut off the water tap and unplug the

appliance from the electricity socket.

10. Open the door and wait for a few minutes before

removing the crockery, in order to avoid burns.

Unload the racks, beginning with the lower level.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle

selection process it is possible to change the cycle,

provided that it has only just begun: press and hold

the START/RESET button for 4 seconds. After one

long beep and three short beeps, the WASH CYCLE

PHASE indicator light will switch off: select the new

cycle and switch the machine back on by pressing

the START/RESET button.

Adding extra crockery

Press the ON/OFF button and open the door, taking

care to avoid the escaping steam, and place the

crockery inside the dishwasher. Press the ON/OFF

button again: the cycle starts from the point at which

it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if

there is a power cut, the cycle stops. It starts again

from the point at which it was interrupted once the

door has been shut or the electricity supply is

restored.

Loading the detergent

A successful wash also depends on the correct

amount of detergent being used, as recommended

by the manufacturer. Exceeding the recommended

amount does not result in a more effective wash and

pollutes the environment.

compartment Acompartment A

compartment A: Washing detergent

compartment Bcompartment B

compartment B: Pre-wash detergent

1. Open cover C by

pressing button D.

2. Pour in the detergent

after consulting the

Wash cycle table

• for powder detergent

use compartments A

and B

• for tablets, use

compartment A and the

bottom of the

appliance, i.e. when the

cycle requires 1 tablet, place it in compartment A

and close the cover; when it requires 2, place the

second tablet at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Start-up and use

Washing options*

Delayed start

It is possible to delay the start time of the cycle by

12, 9, 6 or 3 hours.

1. Press the DELAYED START button: every time the

button is pressed, a beep is emitted and the

selected delayed start indicator light illuminates.

2. Select the wash cycle and press the START/

RESET button: after the beep sounds, the timer

begins counting down.

3. Once this time has elapsed, the indicator light

switches off and the wash cycle begins.

To adjust the delay time and select a smaller period

of time, press the DELAYED START button. To

cancel it, press the button repeatedly until the wash

cycle begins and the WASH CYCLE PHASE

indicator light corresponding to the start of the cycle

in progress illuminates.

* Only available in selected models.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Indesit IDL 55 T4C Instruction for Use Page 17

Comments to this Manuals

Related products and manuals for Dishwashers Indesit IDL 55 T4C