Indesit IT50CWS User Manual download pdf (Page 5)

Installation

WARNING – THIS APPLIANCE MUST BEWARNING – THIS APPLIANCE MUST BE

WARNING – THIS APPLIANCE MUST BE

EARTHED.EARTHED.

EARTHED.

Electrical connection

Electric cookers come without a power supply cable.

The cooker is designed to operate on an electricity

supply which conforms to the electrical data shown

on the Rating Plate. The cooker can be connected to

the mains only after removing the back panel of the

cooker itself with a screwdriver.

! The following installation procedure must be

carried out by a qualified electrician. The electrical

installation must comply with the IEE Regulations,

Building & local By-Lays.

For the installation of the feeding cable carry out the

following operations:

1 Open the terminal

board by inserting a

screwdriver into the

side tabs of the cover.

Use the

screwdriver as a

lever by pushing it

down to open the cover

(see diagram).

2 Loosen the cable

clamp screw and

remove it, using a

screwdriver as a lever

(see figure).

3 Remove the wire

contact screws L-N-

then fasten the wires

under the screw heads, respecting

the colour code: Black/Blue (N), Red/Brown

(L) and Bare Wire/Yellow-Green (

 Once the connections have been made, tighten all

the terminal screws fully.

Fasten the supply cable in place with the clamp

and close the cover of the terminal board.

N.B.:N.B.:

N.B.: the power supply cable must have these minimum

requirements:

Type: H05RR-F

H05VV-F

Section: 3x4 mm

Moving the Cooker

Positioning the Cooker

150 mm

650 mm

The height of the

cooker can be

adjusted by

means of

adjustable feet in

the plinth (900mm

- 915mm). Adjust

the feet by tilting

the cooker from

the side. Then

install the product

into position.

NOTE: This

appliance must

not be fitted on a

platform.

The cooker is

designed to fit

between kitchen

cabinets spaced

500mm apart. The

space either side

need only be

sufficient to allow

withdrawal of the

cooker for

servicing. It can

be used with

cabinets one side

or both as well as

in a corner setting.

It can also be

used free-

standing.

Adjacent side walls which project above hob level,

must not be nearer to the cooker than 150mm and

should be protected by heat resistant material.

Any overhanging surface or cooker hood should

not be nearer than 650mm.

Before moving your cooker check that it is cool,

and switch off at the cooker control unit.

Movement of your cooker is most easily achieved

by lifting the front as follows:

Open the grill door sufficiently to allow a

comfortable grip on the underside front edge of

the oven roof, avoiding any grill elements.

Note: Note:

Note: Take care in moving the cooker as it is

heavy. Take care to ensure that any floor covering

is not damaged.

Splashplate optional, apply to Parts Department

(see Back Cover for contact number.)

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

Indesit IT50CWS User Manual Page 5

Comments to this Manuals

Related products and manuals for Kitchen Indesit IT50CWS