Indesit IDE 100 EU Instruction for Use download pdf (Page 16)

Salt ......

Salt

The hardness of the water varies from place to place. If

hard water is used in the dishwasher, deposits will form on

the dishes and utensils.

The appliance is equipped with a special softener that uses

a salt specifically designed to eliminate lime and minerals

from the water.

Loading the Salt into the Softener

Always use salt intended for use with dishwashers.

The salt container is located

beneath the lower rack and

should be filled as follows:

1. Remove the lower rack

and then unscrew and

remove the cap from the salt

container;

2. If you are filling the

container for the first time,

fill it with water;

3. Place the end of the

funnel (supplied) into the

hole and introduce about 2 kg of salt. It is normal for a

small amount of water to come out of the salt container.

4. Carefully screw the cap back on.

The salt container should be filled up when the low

salt indicator light "S" flashes.

Once you have loaded the salt for the first time, it is normal

that the low salt indicator light stays on or flashes for about

5 consecutive cycles.

Warning: To prevent rust from forming, we advise you to

load the salt before starting a wash cycle.

Adjusting Salt Consumption

The dishwasher is designed to allow for adjusting the amount

of salt consumed based on the harness of the water used.

This is intended to optimize and

customize the level of salt con-

sumption so that it remains at a

minimum.

Your Local Water Board can

supply the degree of hardness

of the water

in your area.

To adjust salt consumption, pro-

ceed as follows:

1) Unscrew the cap from the salt

container.

2) There is a ring on the container with an arrow on it (see

figure to the side), if necessary, rotate the ring in the anti-

clockwise direction from the "_" setting towards the "+"

sign, based on the hardness of the water being used.

It is recommended that adjustments be made in accord-

ance with the following schema:

Water Hardness

Clarke

degrees

°fH mmol/l

Selector

position

Salt

consum-

ption

(grams/

cycle)

Autonomy

(cycles\2kg)

0 - 14 0 - 17 0 -1,7 / 0 /

14 - 36 18 - 44 1,8 - 4,4 "-" 20 60

36 - 71 45 - 89 4,5 - 8,9 MED 40 40

>71 > 89 > 8,9 "+" 60 25

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 79 80

Comments to this Manuals

No comments

Indesit IDE 100 EU Instruction for Use Page 16

Comments to this Manuals

Related products and manuals for Dishwashers Indesit IDE 100 EU