Indesit CP 057 GT S Instruction for Use download pdf (Page 26)

Adjusting the hob burners’ minimum setting:

1. Turn the tap to the minimum position.

2. Remove the knob and adjust the regulatory screw, which

is positioned inside or next to the tap pin, until the ame is

small but steady.

! If the appliance is connected to a liquid gas supply, the

regulatory screw must be fastened as tightly as possible.

3. While the burner is alight, quickly change the position of

the knob from minimum to maximum and vice versa several

times, checking that the ame is not extinguished.

! The hob burners do not require primary air adjustment.

! After adjusting the appliance so it may be used with a

different type of gas, replace the old rating label with a new

one which corresponds to the new type of gas (these labels

are available from Authorised Technical Assistance Centres).

! Should the gas pressure used be different (or vary slightly)

from the recommended pressure, a suitable pressure regulator

must be tted to the inlet hose in accordance with current

national regulations relating to “regulators for channelled gas”.

Gas oven (CP 057 GT S):

• Open the oven door (to reach the oven burner, remove

the oor);

• loosen the 2 screws which hold the oven burner in place,

remove the burner and replace the nozzles “N” with

suitable ones for the new type of gas according to the

table “Burner and nozzle characteristics”.

• re-assemble all the components, regulate the air in the

burner as well as the minimum ow of the tap.

Adjusting the low ame

• Open the door and remove the oven oor;

• put the oven knob to position maximum and light the burner;

• close the door and wait for about 15 minutes;

• put the knob to position 1 (minimum);

• remove the actual knob and regulate the adjusting screw

situated above the thermostat spindle;

• after regulating the low ame as required, with the burner

lit, change from the high to the low ame position abruptly

for a few times and close the oven door normally, making

sure that the burner does not go out.

Primary air ow control

The oven burners and grill are tted

with the primary air control bushing

“R” (gas oven burners). The primary

air ow is controlled in an appropriate

way when the ame is stable and

even, without killing the ame when

the burner is cold or lighting the

nozzle when the burner is hot.

The flow may be adjusted by

loosening the screw “P” and moving the bushing “R” so

that the opening “X” corresponds to the values in the table

below. Once all the adjustments have been made, fasten

the bushing “R” with the screw “P”.

Burner

Opening "X" (mm)

natural gas "G20"

Opening "X" (mm)

liquid gas "G30-G31"

Oven

rill

6.5

Safety Chain

! In order to prevent the appliance from overturning

accidentally, for example in case of a child climbing

onto the oven door, the safety chains MUST be installed!

The cooker is provided with safety chains that must be

xed with a screw (not supplied as accessory) on the wall

behind the appliance, at the same height as the xing point

on the appliance.

Make sure that the chains are xed in the back of the

cooker, as shown in the drawing, in such way to be tight

and parallel to the oor.

! When the installation process is complete, the chains must

be kept in tension!

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 71 72

Comments to this Manuals

No comments

Indesit CP 057 GT S Instruction for Use Page 26

Comments to this Manuals

Related products and manuals for Ovens Indesit CP 057 GT S