Indesit FH 103 XA/HA Instruction for Use download pdf (Page 24)

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding

racks - can be washed like everyday crockery,

and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive

material or sharp metal scrapers as these could scratch

the surface and cause the glass to crack.

To clean more thoroughly, you

can remove the oven door.

1. Open the oven door fully

(

see diagram

2. Use a screwdriver to lift up

and turn the small levers

located on the two hinges (

see

diagram

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps

F, then pull the door

towards you lifting it out of its

seat (

see diagram

).*

3. Grip the door on the two

outer sides and close it

approximately half way. Pull

the door towards you lifting it

out of its seat (

see diagram

).*

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If

the seals are damaged, please contact your nearest

After-sales Service Centre (

see Assistance

). We

recommend that the oven is not used until the seals

have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

2. Remove the light bulb and replace it with a

similar one: Wattage 25 W, cap E 14.

3. Replace the glass cover (

see diagram

Only on certain models

1 ... 23 24 25 ... 68

Comments to this Manuals

No comments

Indesit FH 103 XA/HA Instruction for Use Page 24

Comments to this Manuals

Related products and manuals for Ovens Indesit FH 103 XA/HA