Indesit SV 39 NAX Instruction for Use download pdf (Page 14)

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out

any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external parts and the rubber seals

may be cleaned using a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the removal of stubborn

stains. After cleaning, rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned after each use, while it is

still lukewarm. Use hot water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding racks - can be washed

like everyday crockery, and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack. For more thorough cleaning purposes, the oven

door may be removed:

1. Open the oven door fully (see diagram).

2. Lift up and turn the small levers located on the two hinges (see diagram).

3. (with glass panel tted to the inside of the

door) Grip the door on the two outer sides and

close it approximately half way. Unlock the

door by pressing on the clamps F, then pull

the door towards you, lifting it out of its slot

(see diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover using a

screwdriver.

2. Unscrew the light bulb and replace

it with a similar one: Wattage 15 W,

cap E 14.

Replace the glass cover, making sure

the seal is positioned correctly (see

diagram).

! Do not use the oven lamp as/for ambient lighting.

Automatic cleaning using the PYROLYTIC cycle

During the PYROLYTIC cycle, the internal temperature of the oven reaches

500°C. When the pyrolytic cycle is activated, food and grime residues are

burnt away. Dirt is literally incinerated.

Keep children away from the appliance during the automatic cleaning cycle

as surfaces may become very hot. Particles may ignite inside the oven as a

result of the combustion process. There is no cause for concern: this process

is both normal and hazard-free.

Before initiating the PYROLYTIC cycle:

• remove large or coarse food residues from the inside of the oven using a

damp sponge. Do not use detergents;

• remove all accessories;

• do not place tea towels or pot holders over the oven handle;

• turn the SELECTOR knob to the “0” position.

! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to

cool down.

! The cycle may only be started once the oven door has been closed.

To activate the PYROLITIC cleaning cycle, press and hold the button

for approximately 4 seconds. The SET TIME KNOB may be used to select

the desired cleaning level; there are three default time settings which cannot

be modied.

1. Economy (ECO): turn the knob towards “ ”. Duration 1 hour.

2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.

3. Intensive (INT): turn the knob towards “ ”. Duration 2 hours.

4. Press the button to conrm.

An end time for the PYROLITIC cycle (as for a normal cooking cycle) may be

programmed (see Programming the automatic cleaning end time).

Safety devices

• the icon on the display, when lit, indicates that the oven door was

automatically locked as soon as the temperature reached a high value;

• the icon indicates that the cleaning cycle may be cancelled

at any time by pressing the button;

• if a malfunction occurs, the heating elements will be switched off;

• once the oven door has been locked, you cannot change the duration and

cycle end time settings.

Glass door

Seal (only on a

few models)

Lamp

Oven

compartment

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Indesit SV 39 NAX Instruction for Use Page 14

Comments to this Manuals

Related products and manuals for Ovens Indesit SV 39 NAX