Indesit B 40 L/CS SF Instruction for Use download pdf (Page 17)

Hobs installation

Fig.3

Securing the appliance to the cabinet

There are three different groups of appliance as far as

installation is concerned:

1- Built-in hobs to be slotted in (Class 3 - see figure 4, detail

H1). In this case it is necessary to make a hole in the worktop

whose measurements match those of the hob. The

measurement at the side should be reduced by 2 cm so as to

ensure that 1 cm of the perimeter of the hob overlaps with and

rests on top of the supporting surface. To slot in the hob

flush with the worktop, the cut-out on this supporting surface

must be lowered (see figure 5), so that both the edge of the

hob and the seal "X" under it can be positioned there.

Before fitting the hob to the worktop, position the seal

provided along the perimeter of the hob, as illustrated in figure

fig.5

2-Built-in hobs (Class 3) with edges lower than 82 mm

(see figure 4, detail H2). To install this type of hob, a hole

large enough to accommodate the whole lower casing of

the appliance must be made on the worktop intended to be

under the hob. Remember to leave a gap of at least 1 cm

between the lower casing and the worktop around the whole

perimeter of the appliance (the underside of the casing can,

however, touch the surface below it).

3-Sit-on hobs (Class 1) with edges higher than 82 mm (see

figure 4, detail H3). In this case, the lower casing of the

hob does not protrude further than the edge of the

appliance. Even when the hob is resting on the worktop, it

will suffice to leave space for the gas supply tube and

electricity supply cable.

The appliance must be fixed to the kitchen cabinets using

suitable fixing accessories (these are provided) which may

vary according to the type of installation required and the

proportions of the appliance.

N.B.: to make maintenance operations more efficient, the

area around the hob must be easily accessible after it has

been installed (i.e. there are no completely shut-off

elements).

in. 45 mm

min. 50 m

82 mm

Fig.4

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Comments to this Manuals

No comments

Indesit B 40 L/CS SF Instruction for Use Page 17

Comments to this Manuals

Related products and manuals for Unknown Indesit B 40 L/CS SF