EN
3
PROGRAMS TABLE
Program
Drying
Available
options
*)
Detergent
container
Duration
of wash
program
(h:min)
**)
Water con-
sumption
(litres/cycle)
Energy con-
sumption
(kWh/cycle)
Tub
B
1
Eco 50°
04:00 9,0 0,74
2
Auto Intensive 65°
-
02:20 - 03:00 16,0 - 18,0 1,2 - 1,4
3
Auto Normal 55°
02:10 - 02:50 14,5 - 16,0 1,05 - 1,25
4
Delicate 45°
-
01:40 12,0 1,0
5
Rapid 30’ 50°
-
-
00:30 9,0 0,50
6
Night 50°
-
03:35 16,5 1,0
7
Extra 65°
-
-
01:30 12,0 1,2
8
Soak
- -
- -
00:10 4,5 0,01
9
Push & Go 50°
-
-
01:20 10,0 1,1
Instructions on wash cycle selection.
1 ECO
Normally soiled crockery. Standard program, the most ecient in
terms of its combined energy and water consumption.
2 AUTO INTENSIVE
Automatic program for heavily soiled dishes and pans (not to be used
for delicate items).
3 AUTO NORMAL
Automatic program for normally soiled pans and dishes.
4 DELICATE
Program for delicate items, which are more sensitive to high tempera-
tures, for example glasses and cups.
5 RAPID 30’
Program to be used for lightly-soiled dishes with no dried food resi-
dues.
6 NIGHT
Suitable for night-time operation of the appliance. Ensures optimal
cleaning and drying performance with the lowest noise emission.
7 EXTRA
Program that allows to wash very big items loaded in the lower rack.
8 SOAK
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
9 PUSH & GO
Everyday wash and dry cycle that ensures great cleaning performance
in a short time without the need to pre-treat dishes.
Notes:
Please note that cycles like “Auto Fast” or “Rapid” are most eective for
lightly soiled dishes.
To reduce consumption even further, only run the dishwasher
when it is full.
PROGRAMS DESCRIPTION
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address: assistenza_en_lvs@indesitcompany.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - O mode consumption: 0.5 W
Comments to this Manuals