Indesit PC 640 N T X AUS Instruction for Use download pdf (Page 10)

3. Replace all the components by completing the above

operations in reverse order.

• Adjusting the burners’ primary air :

Does not require adjusting.

• Setting the burners to minimum:

1. Turn the tap to the low ame position;

2. Remove the knob and adjust

the adjustment screw, which is

positioned in or next to the tap pin,

until the ame is small but steady.

3. Having adjusted the ame to the required low setting,

while the burner is alight, quickly change the position

of the knob from minimum to maximum and vice versa

several times, checking that the ame does not go out.

4. Some appliances have a safety device (thermocouple)

tted. If the device fails to work when the burners are set

to the low ame setting, increase this low ame setting

using the adjusting screw.

5. Once the adjustment has been made, replace the

seals on the by-passes using sealing wax or a similar

substance.

! If the appliance is connected to liquid gas, the regulation

screw must be fastened as tightly as possible.

! Once this procedure is nished, replace the old rating

sticker with one indicating the new type of gas used. Stickers

are available from any of our Service Centres.

! Should the gas pressure used be different (or vary slightly)

from the recommended pressure, a suitable pressure

regulator must be tted to the inlet pipe (in order to comply

with current national regulations).

Post Installation Checks

Perform post installation checks and ensure proper and

safe operation before leaving. Test all burners individually

and in combination.

Leak Check

• Ensure all gas control knobs are in the Off position.

• Ensure the gas supply is switched on.

• Spray a solution of soapy water onto all gas joints

as well as the full length of any flexible hoses.

UNDER NO CIRCUMSTANCES USE A NAKED FLAME

IN CHECKING FOR LEAKS.

If bubbles appear anywhere, turn the gas supply off, check

all connections and retest. If satisfactory operation cannot

be achieved, contact place of purchase or their appointed

agent for service.

Flame check

Turn each burner on, and ensure that the ame is blue with

minimal yellow tipping. If there is signicant yellow tipping,

ame lift off or excessive noise, check pressure and adjust

at the regulator if necessary.

If satisfactory operation cannot be achieved, contact place

of purchase or their appointed agent for service.

Igniter operation

Check that the igniter for each burner successfully ignites

the gas.

If an igniter fails to work, rst remove the plug from the

electrical power outlet, and then check that all the electrical

connections are in place.

If satisfactory operation cannot be achieved, contact place

of purchase or their appointed agent for service.

Low ame setting

Check the low ame setting for each hob burner to ensure

that the minimum ame will not be extinguished by air

draughts.

• Light the burner.

• Turn the control until it engages in the minimum position.

• Ensure the ame is stable and will not be extinguished

by air draughts.

To adjust the minimum ame:

Follow the procedure described in the gas conversion

instruction.

DO NOT MODIFY THIS APPLIANCE IN ANY WAY, OTHER

THAN AS DESCRIBED IN THESE INSTRUCTIONS.

AUS

1 ... 9 10 11 ... 28

Comments to this Manuals

No comments

Indesit PC 640 N T X AUS Instruction for Use Page 10

Comments to this Manuals

Related products and manuals for Hobs Indesit PC 640 N T X AUS