Indesit PC 640 N T X AUS Instruction for Use download pdf (Page 7)

Installation

! Before operating your new appliance please read this

instruction booklet carefully. It contains important information

for safe use, installation and care of the appliance.

! Please keep these operating instructions for future

reference. Pass them on to possible new owners of the

appliance.

Compliance with standards

This cooktop must be installed by an authorised person in

accordance with the requirements of local gas and electrical

authorities, as well as the latest published versions of the

following standards:

• AS/NZS 5601 Gas installation and pipe sizing

• SAA Wiring Rules.

Positioning

! Keep packaging material out of the reach of children. It can

become a choking or suffocation hazard (see Precautions

and tips).

! The appliance must be installed by a qualified and

authorised professional according to the instructions

provided. Incorrect installation may cause harm to people

and animals or may damage property.

Kitchen Ventilation

Where the total input of all appliances exceeds 3 MJ/h for

each cubic metre of the room or enclosure volume, the

space shall be ventilated by one of the methods detailed

below. For the purpose of assessing the adequacy of

ventilation, the space that cannot be isolated by doors is

the ‘volume of a room’.

Natural ventilation direct from outside

Two permanent openings shall be provided directly to

outside. The openings shall be located to ensure the

distance between the top of the upper opening and the

ceiling of the room or enclosure, and the distance between

the bottom of the lower opening and the oor of the room

or enclosure does not exceed 5% of the height of the room

or enclosure. The minimum free ventilation area provided

by each opening shall be calculated using the following

formula:

A = 3 × T

where

A = the minimum free ventilation area (cm

)

T = the total gas consumption of all appliances (MJ/h)

The minimum vertical dimension of any free ventilation

opening shall be 6 mm.

NOTE 1 When used in this Clause, the term ‘directly to

outside’ means any one of the following options, provided

that the ventilation path is unobstructed by building material

or insulation:

(a) Directly through an outside wall (preferred option).

(b) Through to an outside wall but offset.

(d) Into an under oor space ventilated to outside.

(e) Into a roof space ventilated to outside.

NOTE 2 The two openings may be combined provided that

the top and bottom of the opening reach the limits set by

this Clause.

Natural ventilation via adjacent room

Two permanent openings shall be provided in the room

or enclosure. The openings shall be located to ensure the

distance between the top of the upper opening and the

ceiling of the room or enclosure, and the distance between

the bottom of the lower opening and the oor of the room

or enclosure does not exceed 5% of the height of the room

or enclosure.

The minimum free ventilation area provided by each opening

shall be calculated using the following formula:

A = 6 × T

where

A = the minimum free ventilation area (cm

)

T = the total gas consumption of all appliances (MJ/h)

These requirements shall apply to all subsequent rooms

until a room is ventilated to outside, in accordance with the

previous section, or the total input of the appliances does

not exceed 3 MJ/h for each cubic metre of the total volume

of the enclosure and rooms.

The minimum vertical dimension of any free ventilation

opening shall be 6 mm.

NOTE: The two openings may be combined provided that

the top and bottom of the opening reach the limits set by

this Clause.

• Liquid petroleum gas sinks to the oor as it is heavier

than air. Therefore, rooms containing LPG cylinders must

also be equipped with vents to allow gas to escape in

the event of a leak. As a result LPG cylinders, whether

partially or completely full, must not be installed or stored

in rooms or storage areas that are below ground level

(cellars, etc.). It is advisable to keep only the cylinder

being used in the room, positioned so that it is not subject

to heat produced by external sources (ovens, replaces,

stoves, etc. ) which could raise the temperature of the

cylinder above 50°C.

Adjacent cabinetry

The location of connection points is given in the table on

page 5 . For trouble-free operation of appliances installed in

housing units, the minimum distances shown in g.4 should

be observed. It is recommended that the adjacent kitchen

surfaces should be capable of withstanding temperatures

of 65°C. Also, the following must be observed:

• The appliance should be installed next to cabinetry which

is no taller than the top of the cooker hob.

• The wall in direct contact with the back panel of the

cooker must be made of non-flammable material.

During operation of the cooker, the back panel of the

cooker could reach a temperature of 50°C above room

temperature.

• Kitchen cabinets installed next to the cooker that are

higher than the top of the hob, must be at least 600 mm

from the edge of the hob itself.

• If the hood is installed below a wall cabinet, the latter

must be at least 700 mm (millimetres) above the surface

of the hob.

AUS

1 2 3 4 5 6 7 8 ... 28

Comments to this Manuals

No comments

Indesit PC 640 N T X AUS Instruction for Use Page 7

Comments to this Manuals

Related products and manuals for Hobs Indesit PC 640 N T X AUS