Indesit K6G20 W User Manual download pdf (Page 14)

Installation

The following instructions should be read by a qualified

technician to ensure that the appliance is installed, regu-

lated and serviced correctly in compliance with current

standards.

Important: Remember to unplug the appliance from

the mains before making adjustments or doing main-

tenance.

Positioning

Important: This unit may be installed and used only in

permanently ventilated rooms in compliance with current

National Regulations. The following requirements must

be observed:

a) The room must be equipped with an exhaust system

that vents the combustion fumes to the outside. It may

consist of a hood or an electric fan that automatically

starts each time the appliance is turned on.

Flue or Branched Flue System Directly to the Outside

(only for cooking appliances)

b) The room must also have a system to permit proper

air circulation, needed for combustion to occur nor-

mally. The flow of air needed for combustion must not

be less than 2 m

/h per kW of installed power. The air

circulation system may take air directly from the out-

side by means of a pipe with an inner cross section of

at least 100 cm

; the opening must not be able to be

accidentally blocked. For those appliances not

equipped with a safety device for accidental flame loss,

the ventilation apertures must be increased by 100%,

with the minimum being 200 cm

(Fig. A). The system

can also provide the air needed for combustion by in-

direct means, i.e. from adjacent rooms fitted with air

circulation tubes as described above. However, these

rooms must not be common rooms or bedrooms.

(Fig. B)

Detail A Adjacent Room to

Room be Ventilated

Examples of Ventilation Openings Increased Opening Between

Comburent Air Door and Floor

Fig. A Fig. B

c) Intensive and prolonged use of the appliance may re-

sult in the need for supplemental air circulation, e.g.

opening windows or increasing mechanical venting (if

present).

d) Liquified petroleum gas is heavier than the air and,

therefore, settles downwards. Thus, rooms containing

LPG cylinders must also be equipped with apertures

to the outside for ventilation of gas in the case of leaks.

LPG cylinders must not, therefore, be installed or stored

in rooms or storage areas that are below ground level

(cellars, etc.) whether they are partially or completely

full. It is a good idea to keep only the cylinder being

used in the room, positioned so that it is not subject to

heat produced by external sources (ovens, fireplaces,

stoves, etc. ) which are able to increase the tempera-

ture of the cylinder above 50°C.

Levelling Your Appliance (only on certain models)

4 support feet which are adjusted using screws are located

in the lower part of the cooker. These level off the oven

when necessary. It is essential that the cooker be standing

level.

Mounting the legs (only on certain models)

Press-fit legs are supplied which fit under the base of your

cooker.

Installing the Cooker

The appliance can be installed next to cabinets, provided

they are not taller than the hob. If the cooker is placed in

contact with walls or the sides of adjacent cabinets, they

must be capable of withstanding a rise in temperature of

50°C above room temperature. For proper installation of

the cooker, the following precautions must be taken:

a) Kitchen cabinets installed next to the cooker that are

higher than the top of the hob, must be at least 600

mm from the edge of the hob itself.

b) Hoods must be installed according to the requirements

in the installation manual for the hood and, in any case,

at a minimum height of 650 mm.

1 ... 13 14 15 ... 36

Comments to this Manuals

No comments

Indesit K6G20 W User Manual Page 14

Comments to this Manuals

Related products and manuals for Stoves Indesit K6G20 W