Indesit B PP 73 G HA 240S GT Instruction for Use Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
GB
16
2-Built-in hobs (Class 3) with edges lower than 532-Built-in hobs (Class 3) with edges lower than 53
2-Built-in hobs (Class 3) with edges lower than 532-Built-in hobs (Class 3) with edges lower than 53
2-Built-in hobs (Class 3) with edges lower than 53
mm (see figure 2, detail H2).mm (see figure 2, detail H2).
mm (see figure 2, detail H2).mm (see figure 2, detail H2).
mm (see figure 2, detail H2). To install this type of
hob, a hole large enough to accommodate the whole
lower casing of the appliance must be made on the
worktop intended to be under the hob. Remember to
leave a gap of at least 1 cm between the lower
casing and the worktop around the whole perimeter of
the appliance (the underside of the casing can,
however, touch the surface below it). To fit the
appliances, follow the instructions given above in
point 1 or use any supplementary instruction leaflet
that is provided in special cases (fig.7-8).
Clamps are provided to fasten the cooktop to counters
measuring from 20 to 40 mm in thickness. To fasten
the cooktop securely, it is recommended that all the
clamps be used.
3-Sit-on hobs (Class 1) with edges higher than 533-Sit-on hobs (Class 1) with edges higher than 53
3-Sit-on hobs (Class 1) with edges higher than 533-Sit-on hobs (Class 1) with edges higher than 53
3-Sit-on hobs (Class 1) with edges higher than 53
mm (see figure 2, detail H3).mm (see figure 2, detail H3).
mm (see figure 2, detail H3).mm (see figure 2, detail H3).
mm (see figure 2, detail H3). In this case, the lower
casing of the hob does not protrude further than the
edge of the appliance. Even when the hob is resting
on the worktop, it will suffice to leave space for the
gas supply tube and electricity supply cable.
The appliance must be fixed to the kitchen cabinets
using suitable fixing accessories (these are provided)
Fig.8
Fig.6
Fig.7 (for mod XP 73 G )
Fastening Clamps - Assembly DiagramFastening Clamps - Assembly Diagram
Fastening Clamps - Assembly DiagramFastening Clamps - Assembly Diagram
Fastening Clamps - Assembly Diagram
Clamp Position for Clamp Position for
H=30mm H=30mm
H=30mm H=30mm
H=30mm top
H=40mm H=40mm
H=40mm H=40mm
H=40mm top
FrontFront
FrontFront
Front
Clamp Position for
H=20mm H=20mm
H=20mm H=20mm
H=20mm top
BackBack
BackBack
Back
N.B:N.B:
N.B:N.B:
N.B: Use the clamps contained in the "accessory kit."
640-680 mm
8 mm
640-680 mm
8 mm
Page view 15
1 ... 15 16 17 ... 76

Comments to this Manuals

No comments