Indesit B PP 73 G HA 240S GT Instruction for Use Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
GB
21
! The position of the corresponding gas burner or
electric hotplate is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
0 Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise to the
maximum setting.
Since the burner is fitted with a safety device, the
knob should be pressed for approximately 2-3
seconds to allow the automatic device keeping the
flame alight to heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding knob
as far as possible and turning it anticlockwise
towards the maximum setting.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the “0” position).
Since the burner is equipped with a safety device,
after lighting the burner keep the knob pressed in for
about 2-3 seconds to allow the device which keeps
the flame lit automatically to heat up.
Practical advice on using the burners
To ensure the burners operate efficiently:
Use cookware which is suited to each burner (see
table) in order to prevent the flames from
extending beyond the base of the pans, and so
that the edges of the pans themselves do not
reach over the perimeter of the hob.
Always use cookware with a flat base and a cover.
When the contents of the pan reach boiling point,
turn the knob to minimum.
To identify the type of burner, refer to the designs in
the section entitled, "Burner and Nozzle
Specifications".
Make sure the pans do not overlap the edges ofMake sure the pans do not overlap the edges of
Make sure the pans do not overlap the edges ofMake sure the pans do not overlap the edges of
Make sure the pans do not overlap the edges of
the hob while it is being used.the hob while it is being used.
the hob while it is being used.the hob while it is being used.
the hob while it is being used.
Start-up and use
Note When there is no electricity supply, the burners can be
lit with a match after turning the control knob to the flame
position.
To turn on one of the burners, place a lighted match or
lighter near the burner, press the knob all the way in and
turn it anti-clockwise to the "High" setting.
No
te
Burner ø Pan Diameter (cm)
A.Auxiliary 614
B.Semi-rapid 1520
C.Rapid 21 – 26
D. Triple ring 24 - 26
Page view 20
1 ... 20 21 22 ... 76

Comments to this Manuals

No comments